Cartridge Tonearm Compliance Calculator

Cartridge Tonearm Compliance Calculator. I have used calculations similar to the above tonearm effective mass calculator at vinyl engine to consider the optimum total effective mass for a given phono cartridge. Plug this in along with cartridge and tonearm mass and you.

EdAInWestOC's Stereo Stuff from www.edsstuff.org

Japanese companies often use compliance at 100hz (multiply by about 1.7 to get a 10hz figure) and american companies sometimes state a static figure (halve that to get a. A = 1.000 ÷ 2 π = 159.23 (you can also use the fixed value of 159) m = sum of all masses (arm, screws and cartridge) c = compliance (at 10 hz) for example: There is a calculator on one of the vinyl sites that can tell you if you have a good combination.

Source: www.edsstuff.org

Neither is inherently bad, they just need to be matched with the right tonearm to make sure the entire system works together. The compliance field is for the cartridge compliance.

Source: www.ortofon.com

A tonearm whose effective mass is rated between 11 and 25 grams is considered moderate mass (e.g. Do the analysis of the data and see if there are some recommendations to be made on matching tonearms and cartridges.

But In Principle High Compliance Is Better Than Low Imo,.

The compliance field is for the cartridge compliance. The resonance calculator works with more parameters to give a more exact resonant frequency. The compliance is restricted by the vtf, meaning too low vtf causes always tracking and tracing problems.

Arm Eff Mass 13G, Compliance 13, Cartridge Weight 7.8G, 0.9G For The Screws (I Weighed Them).

Say we have an arm of with a. The formula for calculating the rf of an arm/cartridge combo is: We will take about what compliance is, how it affect tonearm resonance and how a.

Rule Of Thumb, Low Mass Arms Work With High Compliance Cartridge Low Mass.

For tone arm mass (grams) the voice: Tonearms from other manufacturers like. This system will resonate at a.

Do The Analysis Of The Data And See If There Are Some Recommendations To Be Made On Matching Tonearms And Cartridges.

Neither is inherently bad, they just need to be matched with the right tonearm to make sure the entire system works together. Does cartridge compliance still confuse you? The cantilever of a turntable cartridge has a certain stiffness.

It Pretty Much Acts Like A Spring And Is Part Of A Mechanical System That Involves The Entire Tonearm.

Plug this in along with cartridge and tonearm mass and you. There is a calculator on one of the vinyl sites that can tell you if you have a good combination. Arms above 25 grams of mass.